You are here: Installation and Maintenance Guide > Calibration > Calibration Procedures > Center XYZ

Center XYZ

The Center XYZ calibration command is available by selecting Calibrate > Scanner > Center XYZ from the main menu. This selection automatically performs the following two routines:

  1. Centers the scanner in Z and calibrates the Z sensor
  2. Does an XY spiral and centers the scanner in XY

This command is useful for diagnosing issues with the Z sensor and for correcting XY hysteresis.

 

www.bruker.com Bruker Corporation
www.brukerafmprobes.com 112 Robin Hill Rd.
nanoscaleworld.bruker-axs.com/nanoscaleworld/ Santa Barbara, CA 93117
   
  Customer Support: (800) 873-9750
  Copyright 2010, 2011. All Rights Reserved.